Skip to content

Independent Viking kitchen appliances only

Mon–Fri, 8am–6pm Sat, 9am–4pm

The line

What we take in, and what we do not

One manufacturer. We do not take work on any other brand, so the parts, the manuals and the failure patterns are the ones we see every week.

Close crop of a stainless cooktop with one burner dismantled and the cast grates set aside on the counter
Every job starts the same way: the part comes off before anything is quoted.

The line

Which appliance is giving trouble?

Ranges & Rangetops

Viking Range and Rangetop Burner Faults

Burners that will not light, ovens that drift off setpoint, and doors that no longer seal. Sealed burner and oven work on Viking ranges.

Dishwashers

Viking Dishwasher Not Draining or Drying

Blocked spray arms, drain pumps full of glass grit, and dishes that come out chalky. Built-in dishwashers, diagnosed in the order the water travels.

Undercounter & Wine

Viking Wine Cabinet Drifting Off Setpoint

Wine cabinets drifting off setpoint, beverage centers icing up, and undercounter ice machines skipping harvests. Small boxes in very tight spaces.

Not this bench

The work we send elsewhere

Foundry Line Appliance is a kitchen appliance shop. We do not repair, install or service heating, air conditioning or the ductwork that serves them, and we do not sell appliances.

  • Furnaces, heat pumps and air handlers
  • Air conditioning, indoors or out
  • The duct system that heats and cools the house
  • Water heaters, pool heaters and attic fans

A range hood is kitchen equipment and we work on it: blower, speed control, damper, baffle filters and the duct that serves the cooking suite. A make-up air path, a furnace, an air handler or a house duct system is a mechanical contractor, and we will say so on the phone.

Said once, plainly: Viking Range, LLC makes the cooking and refrigeration equipment these six pages are about. The town of the same name sits in Indian River County, a long way south of Duval County, and no heating or air conditioning work is done here for anyone.

What it costs

What does a Viking repair cost?

The visit and the whole diagnostic sequence are $80 flat, and that comes off the bill the moment you approve the work. The work below has run $200–$970 in parts and labor after that, and the figure on your estimate is written down before a part is ordered.

Typical repair bands, Viking equipment, parts and labor together.
Work Parts and labor
$80 diagnostic Flat, credited toward the repair
Igniter or burner assembly $200–$530
Oven thermostat or heating element $200–$570
Control board or touch panel $410–$970
Refrigeration fan or defrost system $240–$650

A band is where the work has landed, not a quote. You get a written estimate before any part is ordered or any tool comes out. 90 days on labor, 365 days on parts. The whole table is on the pricing page.

Asked on the phone

What do people ask before they book?

What does a Viking repair cost?
$80 flat to come out and find the fault, and that comes off the bill the moment you approve the repair. Past that the job lands in a band: igniter or burner assembly $200–$530, oven thermostat or heating element $200–$570. You get a written estimate before any part is ordered or any tool comes out. Every repair carries 90 days on labor and 365 days on parts.
Is a built-in appliance worth repairing?
Set the band against what the replacement costs: professional range, the usual repair-or-replace comparison $6,500–$14,500; built-in refrigerator or column $9,500–$17,500; built-in dishwasher $1,600–$3,200. Those are appliance-only figures, before delivery, fitting or cabinetry, which is why a repair inside the bands above usually wins by a wide margin. Where it does not, we say so at the diagnostic rather than quote the work.
Do you work on anything other than Viking?
No. Viking Range, LLC builds kitchen appliances — ranges, rangetops, wall ovens, built-in refrigeration, ventilation hoods and dishwashers — and that equipment is the whole of what this shop takes in. One make means the parts on the van, the manuals and the failure patterns are the ones we see every week. We are an independent repair shop.
What happens on the first visit?
The technician runs the full diagnostic sequence on the appliance, shows you what he measured, and writes the estimate before anything is ordered. That is the $80, and it comes off the repair. Calls run Mon–Fri, 8am–6pm and Sat, 9am–4pm. EPA Section 608 certified technicians for sealed-system refrigerant work.

What customers said

After a call, in their words

4.3 out of 5, across 77 published customer reviews. Read every one of them.

  • The convection fan screeched at the start of every bake. He found the motor bearing dry and the blade clipping the shroud after a rack had been forced in. New motor, straightened shroud, silent oven.

    Thea G.

  • One burner clicked and clicked before it lit, which is not a sound you want from gas. The spark module was firing weak. He changed it and cleared the ports on the rest while the tops were off.

    Beatrix S.

  • The undercounter unit kept tripping the breaker it shares with half the kitchen. He proved it was the start relay rather than the house wiring, fitted one, and told me what that old circuit is good for.

    Leopold T.

Book the visit

Tell us the model. We bring the part.

Viking only. Duval County, citywide. Flat $80 diagnostic. It is credited toward the repair if you approve the work.

Diagnostic
$80 flat
Labor
90 days on labor
Parts
365 days on parts
Weekdays
Mon–Fri, 8am–6pm
Saturday
Sat, 9am–4pm